Забыли пароль на IPO 500, каким образом его можно сбросить?
PS. Раньше ответ был на форуме avaya.linkme но увы, домен больше не доступен
Сброс пароля
Модератор: Administrator
-
- Постоянный участник форума
- Сообщения: 2891
- Зарегистрирован: Пн 07 июл 2008, 16:51
- Откуда: Москва
- Контактная информация:
-
- Постоянный участник форума
- Сообщения: 2891
- Зарегистрирован: Пн 07 июл 2008, 16:51
- Откуда: Москва
- Контактная информация:
6.12.3 Defaulting Security Settings
Procedure: Defaulting Security Settings
This process defaults the IP Office's security settings but does not alter its configuration settings.
1. Attach the serial cable between the PC and the DTE port on the IP Office control unit.
2. Start the terminal program on your PC. Ensure that it has been setup as listed in DTE Port Settings . Within a
HyperTerminal session, the current settings are summarized across the base of the screen.
3.Enter AT (note upper case). The control unit should respond OK.
4.Enter AT-SECURITYRESETALL.
5. You will be prompted to confirm the control unit's MAC address before continuing. Enter the address.
6. The control unit will respond OK when the action has been completed.
7.Close the terminal program session.
8. Manager can now be used to receive and edit the control unit's now defaulted security settings.
Под кнопкой, действительно отдельно сброса пароля нет. Можно конфиг сбросить, но тогда нужен бекап.
10 to 30. Flashing orange Erase Configuration/
Immediate Reboot
Erase the configuration, alarm log and audit trail.
Immediate reboot without waiting for active calls to end.
See Erasing the configuration for full details.
Procedure: Defaulting Security Settings
This process defaults the IP Office's security settings but does not alter its configuration settings.
1. Attach the serial cable between the PC and the DTE port on the IP Office control unit.
2. Start the terminal program on your PC. Ensure that it has been setup as listed in DTE Port Settings . Within a
HyperTerminal session, the current settings are summarized across the base of the screen.
3.Enter AT (note upper case). The control unit should respond OK.
4.Enter AT-SECURITYRESETALL.
5. You will be prompted to confirm the control unit's MAC address before continuing. Enter the address.
6. The control unit will respond OK when the action has been completed.
7.Close the terminal program session.
8. Manager can now be used to receive and edit the control unit's now defaulted security settings.
Под кнопкой, действительно отдельно сброса пароля нет. Можно конфиг сбросить, но тогда нужен бекап.
10 to 30. Flashing orange Erase Configuration/
Immediate Reboot
Erase the configuration, alarm log and audit trail.
Immediate reboot without waiting for active calls to end.
See Erasing the configuration for full details.
Настрою IP Office и классическую Avaya